Brake lockout bracket for UFP actuators. This bracket is used to "lock out" the brakes from functioning when you need to back up an incline. Be sure to remove the key after use.
|
Brass quick disconnect fittings typically installed on the replacement removable tongue hoses.
|
This zinc plated replacement UFP breakaway cable assembly secures to the bumper or frame of your tow vehicle as close to center as possible. Designed to engage your trailer's brakes in the event the couple detaches from the tow vehicle.
|
|
|
Bracket to release a pushrod that may be jammed.
|
Spring for the pushrod release bracket installed in UFP actuators.
|
This product replaces your current removable tongue with one fitted for a UFP brand actuator. If your Atwood actuator is damaged beyond repair or is becoming too costly to repair, this is the cheapest method available to convert.
|
The reservoir diaphragm is located on the master cylinder installed in UFP actuators. There are two components that may need to be replaced, one is composed of rubber and the other is zinc plated.
|
Replacement rollers for UFP brake actuators. Two variants exist, the front zinc plated rollers and the rear nylon rollers.
|
This UFP shock absorber controls random application of the trailer brakes when towing on rough roads. It also ensures smooth operation of the trailers hydraulic brake system when applied and released. Works on all UFP Actuator models.
|
Inner member assembly for the UFP A-60 Actuator, 7500lb capacity. Complete with master cylinder or solenoid, shock absorber, rollers, roller pins, latch assembly, breakaway cable.
|
Inner member assembly for the UFP A-75 Actuator, 7500lb capacity. Complete with master cylinder, shock absorber, rollers, roller pins, latch assembly, and breakaway cable.
|
Hitch pin replacement kit for the UFP A-84 actuator.
|
Inner member assembly for the UFP A-84 Disc/Drum Brake Actuator, 8400lb capacity. Complete with master cylinder, shock absorber, rollers, roller pins, latch assembly, breakaway cable, and back-up solenoid(disc only).
|
UFP Standard Weld-On outer member housing.
Designed for Welding to 3" x 3"/4"/5" straight trailer tongues.
19" L x 4.18" H
Will work for the A-60, A-75, & A-84 actuators.
|
Latch replacement kit for UFP brand actuators. There are two variants of this kit for the A-60 and the A-84 actuators.
|
The boot of the master cylinder works with the push-rod to ensure that fluid is released when pressure is applied to the actuator.
|
Reservoir cap for master cylinders in UFP actuators.
|
Replacement black plastic outer member housing cap covers the access hole to the actuator's master cylinder reservoir plug. Cap is designed to twist lock into place with a simple clockwise turn.
|
Replacement push-rod assembly for use with A-60, A-70, A-75, and A-84 actuators.
|
Replacement nylon pad for hydraulic brake actuators made by UFP. Nylon wear pad provides protection between the inner slide and the outer member housing.
|
The UFP 4" or 5" Retro Fit Outer member is constructed specifically for Mastercraft Trailers that have Reliable brand brake system. (Reliable parts are no longer available) and a swing away tongue, plated. This is the housing only.
|
UFP Roller Pin Assembly Includes:
2 Retaining Rings #32262
2 Washers #32554
1 Roller Pin #34079
|
This brake lockout cap is an option on UFP Brake Actuators. It allows trailers to be backed up over soft ground or up inclines without fully engaging the brakes. Also referred to as a top lockout upgrade.
|
Wear pads are used on UFP actuators to keep steel components from grinding against other components.
| |